Automatic COBRA Manual de Instalação Página 23

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 28
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 22
Page 23
RESTORE FACTORY SETTINGS / WIRING VACATION LOCK
RESTORE FACTORY SETTINGS
KEEP ALL TRANSMITTER CODES / RESET ALL OTHER SETTINGS
1. Select Factory Settings mode using the LEARN button on the unit.
Display shows (F)actory Settings (Fig 37).
2. Press and hold button 2 on a pre-coded transmitter for 2 seconds
until the decimal point stays on, release until the decimal
point turns off, then press and hold button 2 again. The
decimal point will fl ash for 2 seconds. The display will fl ash
CL‘ (Clear) twice and then show ‘r‘ (Reset) once the settings
have been restored to the factory defaults.
ERASE ALL TRANSMITTERS / RESET ALL OTHER SETTINGS
1. Turn off the power.
2. Press and hold INSTALL button while turning on the power (Fig 38).
The display will fl ash ‘CC‘. The display will turn off for 2 s
econds and then fl ash ‘CL‘ (Clear) twice. Once the settings
have been restored to factory settings the display will show
r‘ (Reset).
3. Release the INSTALL button.
WIRING VACATION LOCK/BMS (Building Maintenance
System) TERMINAL
When a button programmed for vacation mode is pressed, the door
will not respond to any other transmitters after the door reaches its
close position until this mode is reversed.
If there is no transmitter button programmed for vacation mode,
then the terminal will function as a BMS input. When the door reaches
its close position, the door will be forced to open and then opener will
freeze until it is powered up again
Installation
1. Disconnect power to the opener.
2. A normally open non-latching push button must be hard wired
between the COM and LCK terminals as shown in Fig 39.
3. Route and clip wires to avoid any mechanical damage to wiring.
4. Reconnect power supply and test the function.
/($51 ,167$//
.
FIG 37
/($51 ,167$//
.
FIG 38
Press and Hold
When Power Turned O
n
ALM
LT
LCK
24V
OSC
COM
COM
PE
P1
P2
FIG 39
Vista de página 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Comentários a estes Manuais

Sem comentários